Details
Spanjaard Graphite Spray is a dispersion of very fine particles of graphite in an air drying resin. It provides lubrication when oils and greases cannot be used. It is available in an aerosol spray.
Applications
- Protective Coating
It prevents corrosion during shipping and storage. Thus expensive parts can be protected from rust and are prelubricated, ready for immediate use.
- High Temperature Lubrication
It provides a stable lubricating film at temperatures of -180C to 350C. Even though resin breakdown starts at this temperature, the Graphite continues to act as a dry lubricant up to 450C.
- Dry Lubrication
It is the answer when problems are caused by the application of conventional wet lubricants and provides dry lubrication in dusty conditions.
Application Instruction
1. Check compatibility of solvents contained in Spanjaard Graphite Spray by testing on a small hidden area of surface to be sprayed.
Note
Phosphating or grit blasting after degreasing increases the ability of the Spanjaard Graphite Spray to bond to the surface of the component.
Contact our sales consultant in area:
Malaysia, Selangor (Klang, Puchong, Shah Alam, Subang), Kuala Lumpur (Sungai Buloh), Negeri Sembilan (Seremban), Melaka, Johor (Johor Bharu, Muar, Batu Pahat), Pahang (Temerloh, Kuantan), Kelantan (Kota Bahru), Terengganu (Kuala Terengganu), Perak (Ipoh), Kedah (Sungai Petani), Perlis, Penang (Bukit Mertajam, Butterworth, Seberang Prai), Sabah (Kota Kinabalu), Sarawak (Kuching), WP Putrajaya, WP Labuan, Indonesia, Singapore, Thailand, Philippines, Vietnam, Laos, Myanmar, Cambodia, Brunei.
Application Instruction
1. Check compatibility of solvents contained in Spanjaard Graphite Spray by testing on a small hidden area of surface to be sprayed.
2. Thoroughly degrease the component to be treated, preferably with a safety solvent, e.g. Spanjaard Electric Motor Cleaner which leave no residue.
3. Shake the aerosol can vigorously and apply one or more thin layers of Spanjaard Graphite Spray allow ing 3 minutes drying for each coat.
4. After aerosol coating, wait 24 hours for the resin to cure at room temperature or cure at 250C for one hour.
Note
Phosphating or grit blasting after degreasing increases the ability of the Spanjaard Graphite Spray to bond to the surface of the component.
Contact our sales consultant in area:
Malaysia, Selangor (Klang, Puchong, Shah Alam, Subang), Kuala Lumpur (Sungai Buloh), Negeri Sembilan (Seremban), Melaka, Johor (Johor Bharu, Muar, Batu Pahat), Pahang (Temerloh, Kuantan), Kelantan (Kota Bahru), Terengganu (Kuala Terengganu), Perak (Ipoh), Kedah (Sungai Petani), Perlis, Penang (Bukit Mertajam, Butterworth, Seberang Prai), Sabah (Kota Kinabalu), Sarawak (Kuching), WP Putrajaya, WP Labuan, Indonesia, Singapore, Thailand, Philippines, Vietnam, Laos, Myanmar, Cambodia, Brunei.
View more about Graphite Spray - Spanjaard Malaysia on main site